IEEE 2960-2023

$30.33

IEEE Guide for Testing Equipment for Direct Current Electrical Energy Meters (Approved Draft)

Published By	Publication Date	Number of Pages
IEEE	2023

Guaranteed Safe Checkout

Category: IEEE

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

New IEEE Standard – Active. Stationary Meter Test Units (MTUs) permanently installed in laboratories, used for testing and calibration of direct current electrical energy meters, in particular for their type test, acceptance test, and verification test, are applied to in this guide. The requirements for automatic MTUs and applies to newly manufactured MTUs to test electrical energy meters on direct current systems with a voltage up to 1 500 V is covered. Finally, it should be noted that the entire guide does not contain normative requirements

PDF Catalog

PDF Pages	PDF Title
1	IEEE Std 2960™-2023 Front cover
2	Title page
4	Important Notices and Disclaimers Concerning IEEE Standards Documents
8	Participants
10	Introduction
11	Contents
12	1. Overview 1.1 Scope 1.2 Purpose 1.3 Word usage
13	2. Normative references 3. Definitions, acronyms, and abbreviations 3.1 Definitions
14	3.2 Acronyms and abbreviations
15	4. MTU and methods of testing DUT 4.1 MTU 4.2 Methods of testing DUT
17	5. Electrical values and requirements 5.1 Mains supply 5.2 The requirements of measurement performance of the complete MTU
18	5.3 Output values and ranges of the test circuits
20	5.4 Error calculation system
21	5.5 Maximum permissible error requirements for the working standard 6. Construction and insulation requirements of MTU 6.1 Construction requirements
22	6.2 Insulation requirements
23	7. Marking requirements 7.1 General
24	7.2 Labels, signs, and signals 7.3 Other information 8. Climatic conditions for MTU 8.1 Normal environmental conditions
25	8.2 Extreme environmental conditions 8.3 Temperature limits 9. Electromagnetic compatibility
26	10. Test methods of electrical values and requirements 10.1 Test conditions 10.2 Conformity inspection by visual inspection 10.3 Error test
28	10.4 Repeatability of the measurements 10.5 Output stability of power
29	10.6 Short-term stability 10.7 Consistency of multiple output 10.8 RMSR of the current and voltage circuits 10.9 Error of the working standard 11. Test items
30	11.1 Type tests 11.2 Acceptance tests 11.3 Verification tests
31	Back cover