BS ISO 2285:2019 – TC:2020 Edition
$134.27
Tracked Changes. Rubber, vulcanized or thermoplastic. Determination of tension set under constant elongation, and of tension set, elongation and creep under constant tensile load
| Published By | Publication Date | Number of Pages |
| BSI | 2020 | 41 |
This document specifies a number of methods of determining the dimensional changes in test pieces of vulcanized or thermoplastic rubber during and after tensile loading for relatively short periods under constant elongation or constant loading.
The constant-elongation test is intended to measure the ability of rubbers to retain their elastic properties after extension, at a standard laboratory temperature, to a specified strain which is maintained for a specified time at the same or at a specified higher temperature and then released at the test temperature or at the standard laboratory temperature.
The constant-load test specifies a method for the determination of elongation, creep and tension set of rubbers subjected to a constant load at standard laboratory temperature.
The test methods are intended to measure the elastic properties of rubber in the hardness range 20 IRHD to 94 IRHD.
The creep measurement is not intended for product design or the evaluation of low-creep materials. For these, ISO 8013 applies, and there is no agreement between the results of this test and those of ISO 8013.
The constant-load test is primarily intended for the measurement of state of cure and the quality control of thin-walled products. An increase in the state of cure or degree of crosslinking is usually reflected in a decrease in set, creep or elongation.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 23 | National foreword |
| 27 | Foreword |
| 28 | 1 Scope 2 Normative references |
| 29 | 3 Terms and definitions 4 Apparatus 4.1 Constant-elongation measurements |
| 30 | 4.2 Constant-load measurements |
| 31 | 5 Calibration 6 Test pieces 6.1 Preparation 6.2 Test pieces for testing under constant elongation 6.2.1 Strip test pieces 6.2.2 Strip test pieces with enlarged ends |
| 32 | 6.2.3 Ring test pieces 6.3 Test pieces for testing under constant load 6.4 Marking 6.4.1 General 6.4.2 Tests at constant elongation |
| 33 | 6.4.3 Tests at constant load 6.5 Number of test pieces 6.6 Time interval between forming and testing 6.7 Conditioning 7 Procedure 7.1 Testing under constant elongation 7.1.1 Measurement of the test pieces 7.1.2 Stretching the test pieces 7.1.3 Exposure at the test temperature |
| 34 | 7.1.4 Test conditions |
| 35 | 7.2 Testing under constant load 7.2.1 General 7.2.2 Elongation 7.2.3 Creep 7.2.4 Tension set |
| 36 | 8 Expression of results 8.1 General 8.2 Constant elongation 8.3 Constant load 9 Test report |
| 38 | Annex A(normative) Calibration schedule |
| 40 | Bibliography |
Related products
-
BS ISO 2285:2019
Rubber, vulcanized or thermoplastic. Determination of tension set under constant elongation, and of tension set,…
