BS EN 62442-1:2011:2012 Edition
$102.76
Energy performance of lamp controlgear – Controlgear for fluorescent lamps. Method of measurement to determine the total input power of controlgear circuits and the efficiency of the controlgear
| Published By | Publication Date | Number of Pages |
| BSI | 2012 | 22 |
IEC 62442-1:2011 defines a measurement and calculation method of the total input power for controlgear – lamp circuits when operating with their associated fluorescent lamp(s). The calculation method for the efficiency of the lamp controlgear is also defined. This International Standard applies to electrical controlgear lamp circuits consisting only of the controlgear and the lamp(s). It is intended for use on a.c. supplies up to 1 000 V at 50 Hz or 60 Hz.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 6 | English CONTENTS |
| 7 | 1 Scope 2 Normative references |
| 8 | 3 Terms and definitions |
| 10 | 4 General 4.1 Applicability 4.2 Declaration of ballast lumen factor 4.3 Dimmable controlgear 4.4 Multi-wattage and/or multi-lamp controlgear 4.5 Accuracy of measurement 4.6 Sampling of controlgear for testing |
| 11 | 4.7 Number of samples 4.8 Conditioning of lamps 4.9 Test voltages and frequencies 5 Method of measurement and calculation of total input power of controlgear –lamp circuits and the efficiency of controlgear 5.1 Correction for ballast lumen factor 5.2 Method of measurement Table 1 – Typical nominal electricity supply details for some regions |
| 12 | 5.3 Measurement and calculation of the total input power of magnetic wire wound controlgear – lamp circuits 5.4 Calculation of the efficiency of magnetic wire wound controlgear 5.5 Measurement and calculation of the total input power of electronic controlgear –lamp circuits |
| 14 | 5.6 Calculation of the efficiency of electronic controlgear 5.7 Measuring the standby power Figures Figure 1 – Configuration of lamp and photocell sensor |
| 15 | Annex A (normative) Energy performance measurement setup Figure A.1 – Measurement of magnetic wire wound controlgear – lamp circuits |
| 16 | Figure A.2 – Measurement of a.c. supplied electroniccontrolgear – lamp circuits Figure A.3 – Test setup for measuring standby power |
| 17 | Figure A.4 – Side view of light output measurement system Figure A.5 – Top view of light output measurement system |
| 19 | Annex B (informative) Application of the reference ballast whenassessing lamps in electronic operation |
| 20 | Bibliography |
Related products
-
BS EN 62442-1:2011+A11:2017:2018 Edition
Energy performance of lamp controlgear – Controlgear for fluorescent lamps. Method of measurement to determine…
