ASTM-F1233:2008 Edition(Redline)

$30.55

F1233-08 Standard Test Method for Security Glazing Materials And Systems (Redline)

Published By	Publication Date	Number of Pages
ASTM	2008	16

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

Significance and Use

This test method is based on field experience rather than laboratory analysis. It provides a basis for the comparative evaluation of ballistic/forced entry/containment resistance of security glazings and systems and should not be used to establish or confirm the absolute prevention of forcible entries or forced exits. This test method defines three factors which determine the success or failure of any attempt to forcefully enter (or exit) the glazing or system. They are: ( 1 ) the tools employed, ( 2 ) the techniques and methods used by the attackers, and ( 3 ) the total time available to effect the entry or exit. This test method defines two of the three factors (tools and techniques) and allows the third (duration) to vary in order to establish levels of forced entry or exit resistance.

1. Scope

1.1 This test method sets forth procedures whose purpose is limited to the evaluation of the resistance of security glazing materials and systems against the following threats:

1.1.1 Ballistic Impact,

1.1.2 Blunt Tool Impacts,

1.1.3 Sharp Tool Impacts,

1.1.4 Thermal Stress , and

1.1.5 Chemical Deterioration.

Note 1—Specifically exempted from this test method are the use of power (motor or engine-driven) tools or devices, explosives, military ordinance (excepting small arms) and tools, processes or devices requiring more than two persons to transport and operate.

1.2 The values stated in inch-pounds are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific warning statement, see Warning in 10.1.1.6.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

A36/A36M Specification for Carbon Structural Steel A53/A53M Specification for Pipe, Steel, Black and Hot-Dipped, Zinc-Coated, Welded and Seamless A574 Specification for Alloy Steel Socket-Head Cap Screws F1029 Guide for Selection of Physical Security Measures for a Facility

Keywords

asset level; ballistic attack; ballistic impacts; ballistic penetration; blunt tool impacts; body passage; chemical deterioration; forced entry; glazing classification; glazing system tests; passage of contraband; physical attack; relation ballistic threats; security glazing; security glazing materials; security glazing systems; spall; thermal stress; threat level; witness plate; Sledge hammer test; Stress–building materials/applications; Thermal stress; Thermal testing; Field testing; Fire axe test; Forced entry resistance; Glazing (security) materials/systems; Impact testing–security systems/equipment; Physical security; Pipe/sledge hammer test; Propane torch test; Security systems and equipment; Sharp-tool impacts; Ammunition; Angle iron/sledge hammer test; Ballistic test; Blunt-tool impacts; Chemical deterioration; Chise

Additional information