ASTM-E929 2005

$40.63

E929-83(2005) Standard Test Method for Measuring Electrical Energy Requirements of Processing Equipment

Published By	Publication Date	Number of Pages
ASTM	2005	7

Guaranteed Safe Checkout

Categories: 03.100.50 - Production. Production management, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM E929-83-Reapproved2005

Historical Standard: Standard Test Method for Measuring Electrical Energy Requirements of Processing Equipment

ASTM E929

Scope

1.1 This test method covers the determination of the energy and power requirements of processing equipment using an electrical metering system.

1.2 This test method can be used to measure energy and power requirements of processing equipment driven by an electrical motor operating on alternating current.

1.3 This test method includes instructions for installation and checkout of the energy metering system, procedures for measuring and recording energy usage, and methods for calculating the average gross power, average freewheeling power, and average net power requirements of processing equipment.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For hazard statements, see Section .

Keywords

ICS Code

ICS Number Code 03.100.50 (Production. Production management)

DOI: 10.1520/E0929-83R05

PDF Catalog

PDF Pages	PDF Title
1	Scope Terminology Summary of Test Method Significance and Use Apparatus
2	Hazards Equipment Calibration Procedure FIG. 1
3	Calculation
4	FIG. 2
5	Precision and Bias FIG. 3
6	A1. PROCEDURES FOR CHECKING METER INSTALLATIONS A1.1 Single Phase A1.2 Three-Phase, Three-Wire A1.3 Three-Phase, Four-Wire Delta (Two Stators) A1.4 Three-Phase, Four-Wire “Y” (Two Stators) A1.5 Time Load Method (Not to be used for calibration)
7	TABLE A1.1

Additional information

Standard Title	E929-83(2005) Standard Test Method for Measuring Electrical Energy Requirements of Processing Equipment
Published Code	ASTM
Publication Date	2005
Pages Count	7
ICS Codes	03.100.50 - Production. Production management