🔥🔥 Don’t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

🔍
ASTM-D5031/D5031M

ASTM-D5031/D5031M

$40.63

D5031/D5031M-13 Standard Practice for Enclosed Carbon-Arc Exposure Tests of Paint and Related Coatings

Published By Publication Date Number of Pages
ASTM N/A 6
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

ASTM D5031/D5031M-13-Reapproved

Historical Standard: Standard Practice for Enclosed Carbon-Arc Exposure Tests of Paint and Related Coatings

ASTM D5031/D5031M

Scope

1.1 This practice covers the selection of test conditions for accelerated exposure testing of coatings and related products in enclosed carbon arc devices operated according to Practices G151 and G153. This practice also covers the preparation of test specimens, the test conditions suited for coatings, and the evaluation of test results. Table 1 describes commonly used test conditions.

1.2 This practice does not cover filtered open-flame carbon-arc exposures of paints and related coatings, which is described in Practice D822/D822M. Another procedure for exposing these products is covered by Practice D3361/D3361M, in which the specimens are subjected to radiation from an unfiltered open-flame carbon arc that produces shorter wavelengths and higher levels of short wavelength radiation than filtered open flame or enclosed carbon arcs.

Note 1—Practice D3361/D3361M requires use of open-flame carbon-arc apparatus with automatic humidity control.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

carbon arc; degradation; exposure; light exposure; ultraviolet; weathering

ICS Code

ICS Number Code 87.040 (Paints and varnishes)

DOI: 10.1520/D5031_D5031M-13

Related products

ASTM-D5031/D5031M
$40.63