ASTM-D1685:2005 Edition
$35.75
D1685-05 Standard Test Method for Traces of Thiophene in Benzene by Spectrophotometry (Withdrawn 2009)
Published By | Publication Date | Number of Pages |
ASTM | 2005 | 4 |
ASTM D1685-05
Withdrawn Standard: Standard Test Method for Traces of Thiophene in Benzene by Spectrophotometry (Withdrawn 2009)
ASTM D1685
Scope
1.1 This test method covers the determination of thiophene in benzene in which the thiophene concentration is between 0.1 and 250 mg/kg.
1.2 Contaminating materials that are darkened by sulfuric acid interfere and must be compensated for by a sample blank determination. Neither carbon disulfide in concentrations as high as 100 mg/kg nor water as high as the level of saturation will interfere.
1.3 Contaminating materials may occasionally cause the color development in this test method to be time dependent and may also contribute to spectral interferences at 589 nm. Consequently, test results indicating substantial thiophene, that cannot be verified by total sulfur analysis, should be considered suspect.
1.4 In determining the conformance of the test results using this method to applicable specifications, results shall be rounded off in accordance with the rounding-off method of Practice E 29.
1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see 7.6, 8.1, and 9.1.
Keywords
benzene; spectrophotometry; thiophene
ICS Code
ICS Number Code 71.080.15 (Aromatic hydrocarbons)
DOI: 10.1520/D1685-05
PDF Catalog
PDF Pages | PDF Title |
---|---|
1 | Scope Referenced Documents Terminology Summary of Test Method Significance and Use |
2 | Reagents Hazards Sampling Preparation of Reagent Blanks and Sample Blank |
3 | Procedure Calculation Precision and Bias Quality Guidelines Keywords TABLE 1 TABLE 2 |