AS 4828.2:2008
$20.15
Degradability of plastics – Methods of test – Determination of brittle point in plastic film using a tensile elongation test
| Published By | Publication Date | Number of Pages |
| AS | 2008-04-28 | 8 |
This Standard specifies a method for the determination of a brittle point for degradable plastic films and sheeting less than 1.0 mm thick. This practice is not intended for determination of the rate of degree of degradation of a plastic film or sheet, but rather, to assess when in the course of its degradation under some condition, a brittle point is reached.
This Standard employs a constant rate of separation of the grips holding the sample and a static load cell.
This Standard is based on the use of grip separation as a measure of extension; however, the desirability of using extension indicators accurate to ±1.0% or better as specified in
ASTM D638 is recognized, and a provision for the use of such instrumentation is incorporated in the procedure.
The results of this test method may be used in conjunction with the results of other test methods in this series, in particular where the plastic specimens have been exposed to ultraviolet radiation, heat and outdoor exposures, prior to testing under this Standard.
The results of this test method are to be used for comparative ranking of test specimens and are not to be used as a performance standard.
Related products
-
AS 4524.2:2005
Bonded abrasive products – Dimensions – Grinding wheels for centreless external cylindrical grinding Published By…
-
AS 4878.5:2001
Methods of test for coated fabrics – Determination of bursting strength Published By Publication Date…
-
AS/NZS 3823.2:2009
Performance of electrical appliances – Air conditioners and heat pumps – Energy labelling and minimum…
-
AS 4123.2:2008
Mobile waste containers – Containers with four wheels with a capacity from 500 L to…
-
AS 4868.1:2008
Copper, lead and zinc sulfide concentrates – Chemical analysis – Determination of gold and silver…
-
AS 4878.7:2001
Methods of test for coated fabrics – Determination of tear resistance Published By Publication Date…
-
AS/NZS 4859.2:2018
Thermal insulation materials for buildings – Design Published By Publication Date Number of Pages AS…
-
AS 4827.1:2008 (R2018)
Coating defect surveys for buried pipelines – Direct current voltage gradient (DCVG) Published By Publication…
-
AS 4806.2:2006 (R2015)
Closed circuit television (CCTV) – Application guidelines Published By Publication Date Number of Pages AS…
-
AS 4873.2:2009
Recommended practice for inductively coupled plasma mass spectrometry (ICP-MS) – Quantitative determination – Water Published…
-
AS 4823.2:2006
Feather and down – Methods of test – Determination of the oxygen index number Published…
-
AS 2898.2:2003
Radar speed detection – Operational procedures Published By Publication Date Number of Pages AS 2003-08-11…
-
AS 2888.2:2002 (R2017)
Methods of testing plastics waste fittings – Method for determining dimensions Published By Publication Date…
-
AS 4848.1:2006
Application specifications for coating systems – Single coat inorganic (ethyl) zinc silicate – Solvent-borne Published…
-
AS 2428.2:2004 (R2016)
Methods of testing smoke/heat release vents – Determination of ability to operate under wind loading…
-
AS 4418.2:2000 (R2016)
Supervisory control and data acquisition (SCADA) – Generic telecommunications and interface protocol – Fire alarm…
-
AS 4828.1:2009
Degradability of plastics – Methods of test – Determination of level of prodegradant ions Published…
-
AS 4878.6:2001
Methods of test for coated fabrics – Determination of tensile strength and elongation at break…
-
AS 4428.4:2004
Fire detection, warning, control and intercom systems – Control and indicating equipment – Intercommunication systems…
-
AS/NZS 4867.2:2002
Cigarette lighters – Child resistance requirements Published By Publication Date Number of Pages AS 2002-03-19…
-
AS 4823.3:2006
Feather and down – Methods of test – Determination for the quantitative composition of feather…
-
AS 4828.4:2008
Degradability of plastics – Methods of test – Test method for heat aging of degradable…
-
AS/NZS 4871.2:2002
Electrical equipment for coal mines, for use underground – Distribution, control and auxiliary equipment Published…
-
AS 4823.5:2006
Feather and down – Methods of test – Measuring the sizes of quilts filled with…
-
AS 4538.2:2000 (R2013)
Guide to the sampling of alumina – Preparation of samples Published By Publication Date Number…
-
AS 4878.4:2001
Methods of test for coated fabrics – Determination of thickness Published By Publication Date Number…
-
AS 4823.4:2006
Feather and down – Methods of test – Sampling in view of tests Published By…
-
AS 4878.9:2001
Methods of test for coated fabrics – Determination of resistance to damage by flexing Published…
-
AS/NZS 4865.2:2008
Performance of commercial ice makers and ice storage bins – Test methods for ice storage…
-
AS/NZS 4968.2:2003
Heavy-road vehicles – Mechanical coupling between articulated vehicle combinations – Testing and installation of fifth…
-
AS 4823.1:2006
Feather and down – Methods of test – Determination of moisture content Published By Publication…
-
AS 4878.2:2001
Methods of test for coated fabrics – Determination of length, width and net mass Published…
-
AS 4428.6:2018
Fire detection, warning, control and intercom systems – Control and indicating equipment – Alarm signalling…
-
AS 4823.7:2006
Feather and down – Methods of test – Determination of the turbidity of an aqueous…
-
AS 1528.2:2001
Tubes (stainless steel) and tube fittings for the food industry – Screwed couplings Published By…
-
AS 4878.8:2001
Methods of test for coated fabrics – Determination of coating adhesion Published By Publication Date…
-
AS/NZS 4864.2:2008
Performance of refrigerated beverage vending machines – Minimum energy performance standard (MEPS) requirements Published By…
-
AS 4758.2:2008
Personal flotation devices – Materials and components – Requirements and test methods Published By Publication…
-
AS 4878.3:2001
Methods of test for coated fabrics – Determination of total mass per unit area, mass…
-
AS 4826.1:2001
Geometric Product Specifications (GPS) – Inspection by measurement of workpieces and measuring equipment – Decision…
