BS EN 60317-0-2:2014
$142.49
Specifications for particular types of winding wires – General requirements. Enamelled rectangular copper wire
| Published By | Publication Date | Number of Pages |
| BSI | 2014 | 30 |
This part of IEC 60317 specifies the general requirements of enamelled rectangular copper winding wires.
The range of nominal conductor dimensions is given in the relevant specification sheet.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 5 | English CONTENTS |
| 7 | INTRODUCTION |
| 8 | 1 Scope 2 Normative references 3 Terms, definitions, general notes and appearance 3.1 Terms and definitions |
| 9 | 3.2 General notes 3.2.1 Methods of test |
| 10 | 3.2.2 Winding wire 3.3 Appearance 4 Dimensions 4.1 Conductor dimensions 4.2 Tolerance on conductor dimensions |
| 11 | 4.3 Rounding of corners Tables Table 1 – Conductor tolerances |
| 12 | Table 2 – Nominal cross-sectional areas of preferred sizes |
| 14 | 4.4 Increase in dimensions due to the insulation 4.5 Overall dimensions 4.5.1 Nominal overall dimensions 4.5.2 Minimum overall dimensions 4.5.3 Maximum overall dimensions Table 3 – Corner radii Table 4 – Increases in dimensions |
| 15 | 5 Electrical resistance 6 Elongation 7 Springiness 8 Flexibility and adherence 8.1 Mandrel winding test 8.2 Adherence test Table 5 – Elongation Table 6 – Mandrel winding |
| 16 | 9 Heat shock 10 Cut-through 11 Resistance to abrasion 12 Resistance to solvents 13 Breakdown voltage 14 Continuity of insulation 15 Temperature index Table 7 – Breakdown voltage |
| 17 | 16 Resistance to refrigerants 17 Solderability 18 Heat or solvent bonding 19 Dielectric dissipation factor 20 Resistance to transformer oil 21 Loss of mass 23 Pin hole test 30 Packaging |
| 19 | Annex A (informative) Nominal cross-sectional areas for preferred and intermediate sizes Table A.1 – Nominal cross-sectional areas (1 of 7) |
| 26 | Annex B (informative) Special tolerances Table B.1 – Tolerances for calculating special maximum and minimum dimensions of grade 2 rectangular wire |
| 27 | Bibliography |
