ASTM-F3606 2022

$34.13

F3606-22 Standard Guide for Additive Manufacturing — Feedstock Materials — Testing Moisture Content in Powder Feedstock

Published By	Publication Date	Number of Pages
ASTM	2022	6

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM F3606-22

Active Standard: Standard Guide for Additive Manufacturing — Feedstock Materials — Testing Moisture Content in Powder Feedstock

ASTM F3606

Scope

1.1 This standard provides guidelines for measuring moisture in powder feedstock used in additive manufacturing (AM). It applies to metallic, ceramic, and polymer AM powder feedstocks.

1.2 This guide provides a description of test methods commonly used to measure moisture and references to their associated standards.

1.3 This guide provides best practice guidance on how to apply the test methods to make them suitable for AM powder characterization.

1.4 This guide is suitable for measuring moisture in AM powder feedstock over the range of 10 µg/g to 10 000 µg/g.

1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords

additive manufacturing; ceramic powders; humidity; metallic powders; moisture content; polymer powder; powder feedstock; water;

ICS Code

ICS Number Code 25.030 (Additive manufacturing)

DOI: 10.1520/F3606-22

Additional information

Standard Title	F3606-22 Standard Guide for Additive Manufacturing — Feedstock Materials — Testing Moisture Content in Powder Feedstock
Published Code	ASTM
Publication Date	2022
Pages Count	6