ASTM-F16:2012 Edition

$40.63

F16-12 Standard Test Methods for Measuring Diameter or Thickness of Wire and Ribbon for Electronic Devices and Lamps

Published By	Publication Date	Number of Pages
ASTM	2012	5

Guaranteed Safe Checkout

Categories: 29.060.10 - Wires, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM F16-12

Historical Standard: Standard Test Methods for Measuring Diameter or Thickness of Wire and Ribbon for Electronic Devices and Lamps

ASTM F16

Scope

1.1 These test methods cover procedures for measuring the diameter or thickness of round and flat wire (ribbon) 0.060 in. (1.52 mm) maximum used in electronic devices and lamps.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

anvil-type measuring devices; diameter and roundness measurements for wire; thickness measurements for ribbon ; Diameter–electronic components/devices; Electrical conductor wire; Anvil-type measuring devices; Lamps; Metal electronic components/devices; Ribbon (for electronic devices); Round wire; Thickness–semiconductors; Wire–electronic devices

ICS Code

ICS Number Code 29.060.10 (Wires)

DOI: 10.1520/F0016-12

PDF Catalog

PDF Pages	PDF Title
1	Scope Summary of Test Method Significance and Use Apparatus
2	Test Specimens Test Conditions Setting Measuring Apparatus FIG. 1 FIG. 2
3	Procedure A for Measuring Fine Round Wire Procedure B for Measuring Large Round Wire Procedure C for Measuring Thickness of Flat Wire and Ribbon Measuring Out-of-Roundness FIG. 3
4	Checking Anvil Errors Calibration of Anvil Pressure Measuring Diameter of Short Lengths TABLE 1 TABLE 2 FIG. 4 FIG. 5
5	Precision and Bias Keywords TABLE 3

Additional information

Standard Title	F16-12 Standard Test Methods for Measuring Diameter or Thickness of Wire and Ribbon for Electronic Devices and Lamps
Published Code	ASTM
Publication Date	2012
Pages Count	5
ICS Codes	29.060.10 - Wires