ASTM-D5 2006(Redline)

The penetration test is used as a measure of consistency. Higher values of penetration indicate softer consistency.

1. Scope

1.1 This test method covers determination of the penetration of semi-solid and solid bituminous materials.

1.2 The needles, containers and other conditions described in this test method provide for the determinations of penetrations up to 500.For guidance in preparing and testing emulsion residue specimens for this test method, please refer to Section 35 of Test Method D 244.

1.3 The values stated in SI units are to be considered standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

D36 Test Method for Softening Point of Bitumen (Ring-and-Ball Apparatus) D244 Test Methods and Practices for Emulsified Asphalts E1 Specification for ASTM Liquid-in-Glass Thermometers E77 Test Method for Inspection and Verification of Thermometers E1137/E1137M Specification for Industrial Platinum Resistance Thermometers E2251 Specification for Liquid-in-Glass ASTM Thermometers with Low-Hazard Precision Liquids

ISO Standard

ISOStandard468 Surface Roughness–Parameters, Their Values and General Rules for Specifying Requirements

Keywords

asphalt; bitumen; penetration;

ICS Code

ICS Number Code 91.100.50 (Binders. Sealing materials); 93.080.20 (Road construction materials)

DOI: 10.1520/D0005-06E01 ASTM International is a member of CrossRef.

Citing ASTM Standards