ASTM-A939/A939M 2020

$35.75

A939/A939M-15(2020) Standard Practice for Ultrasonic Examination from Bored Surfaces of Cylindrical Forgings

Published By	Publication Date	Number of Pages
ASTM	2020	3

Guaranteed Safe Checkout

Categories: 77.140.85 - Iron and steel forgings, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM A939/A939M-15-Reapproved2020

Withdrawn Standard: Standard Practice for Ultrasonic Examination from Bored Surfaces of Cylindrical Forgings (Withdrawn 2021)

ASTM A939/A939M

Scope

1.1 This practice covers a basic procedure of ultrasonically inspecting cylindrical forgings with bores from the bore surface.

1.2 This practice applies to the manual testing mode. It does not restrict the use of other testing modes, such as mechanized or automated.

1.3 This practice applies to cylindrical forgings having bore sizes equal to or greater than 2.5 in. [64 mm].

1.4 This practice is expressed in inch-pound and SI units; however, the inch-pound units shall apply unless the purchase order or contract specifies the applicable “M” specification designation (SI units). The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords

bore inspection; bored turbine rotor; forgings; ultrasonic examination ;

ICS Code

ICS Number Code 77.140.85 (Iron and steel forgings)

DOI: 10.1520/A0939_A0939M-15R20

Additional information

Standard Title	A939/A939M-15(2020) Standard Practice for Ultrasonic Examination from Bored Surfaces of Cylindrical Forgings
Published Code	ASTM
Publication Date	2020
Pages Count	3
ICS Codes	77.140.85 - Iron and steel forgings